inventree-niimbot-plugin mdo

 piramja

last modified: 03 Dec 2024

Introduction

A label printing plugin for InvenTree, which provides support for the Niimbot Label Printers. This plugin is based on the amazing work from labbots/NiimPrintX and modifications from LorisPolenz/NiimPrintX.

Installation

Install this plugin manually as follows:

pip install inventree-niimbot-plugin

Or, add to your plugins.txt file to install automatically using the invoke install command:

inventree-niimbot-plugin

Configuration Options

The following list gives an overview of the available settings. You find them under the InvenTree plugin specific settings.

  • Printer Model Currently supported models are: b1, b18, b21, d11, d110 (but i was only able to test b1 because i don’t have other printer models. Please report back if you can test other models!!).

  • Density The print density. Different models seem to accept only certain values (b1 accepts 1-3).

  • Rotation Rotation angle, either 0, 90, 180 or 270 degrees.

  • Scaling Scaling factor, from 10% to 200%.

  • Vertical Offset Vertical offset, from 0 to 200px.

  • Horizontal Offset Horizontal offset, from 0 to 200px.

Detail section

License: MIT

Status:
Stable
Maintained
Package on PyPI:
inventree-niimbot-plugin

piramja/inventree-niimbot-plugin